[ Charger Specs]

Input
  • Voltage: 100 -240VAC
  • AC power plug type: USA. Optional AC-AC power plug adaptor for international use
  • Current: 0.1VAC
  • Max. input power: 6W
  • Rating frequency: 50/60Hz

Output

  • V-out: 4.2VDC 0.5A
  • Power off: CCCV charging mode, and power off when battery voltage reaches 4.2

[ Battery Charger Instructions ]

  1. The plug for charging the battery on the Syneurgy MT is located on the outside of the control module (plastic housing) on the pad.
  2. Charge only in a dry condition and on a dry surface. The charger should be plugged into a 120V AC wall socket. 
  3. Plug the charger connector (yellow tip) into the Syneurgy MT plug (black housing).
  4. The light on the charger will be red until the battery is fully charged
    (3-4 hours). 
  5. When the battery is charged the light on the charger will turn green. Disconnect the charger.
  6. The Syneurgy MT will operate for up to 30 each 20 minute treatments on a fully charged battery.

Note:
Keep away from children. Never leave the battery unattended during charging. Do not use near flammable material.

Syneurgy MT - Biomimicry, Biomimicry Technology, Battery Charger Instructions for Bio-Magnetic Wave Therapy Device